Pinzas de freno y piezas para Suzuki GS1000

Motorcycle Brake Calipers and Parts for Suzuki GS1000

While the Suzuki GS1000 is designed to handle rough and rugged terrain riding, it is important for the safety of the driver and the vehicle to have a braking system you can rely on. Understanding how the braking system operates and the responsibility of each component that makes it up will go a long way when selecting replacement parts. Knowing that you have dependable stopping abilities will give you more comfort while operating the motorcycle.

These model motorcycles have a disc braking system. This system is engaged when the driver presses the brake lever to bring the bike to a halt. The lever initiates the master cylinder to send pressurized fluid to the calipers located at the wheels. The caliper has pistons which are pressed outward from the force of the fluid. These parts push the brake pads against the rotor or disc, which slows or stops the tires from rotating.

The calipers depend on a pressurized fluid for operation. This allows the brake pads to function. The brake caliper seals are a component of the brake caliper that allows the fluid to remain within the chamber of the brake caliper without leaking out. These seals also prevent dirt or debris from getting into the brake caliper which would cause the various internal parts to experience damage or not allow the fluid to reach the pistons as it is designed to do.

While the brake calipers on a Suzuki GS1000 are designed to handle the tough riding conditions these bikes were built for, the calipers do need to be serviced and replaced over time. Some signs that may be present to warn you that your brake calipers are ready for service include the following.

• Low fluid within the brake fluid reservoir
• Mushy or spongy feel when the brake lever is pressed
• Leaking fluid from around the brake caliper
• Failing braking system that doesnt engage when the lever is used
• Longer braking times

The bleeder valve allows you to remove air from the brake lines of your bike. If the fluid doesnt flow freely through these needles, it may signal that there is a block in the valve. You can check this by using a pin to open up the end hole of the valve. If you still experience problems, you will need to change the bleeder valve to ensure accurate operation and control of your bikes braking system.

Every brake caliper rebuild kit may be different in which replacement parts are included. However, a complete brake caliper rebuild kit includes two pads, complete seal package, bushings and O-rings, and a piston. It is important to look at your vehicles service manual to ensure that the rebuild kit will work as designed on your bike.