LED Lights for Dodge Ram 2500

LED Lights for Dodge Ram 2500

LED light technology is an innovation befitting of the commanding presence that emanates from your Dodge Ram. Tiny light-emitting diodes (LEDs) impart a number of unique benefits. Use this guide to help find LEDs that perfectly complement the imposing frame of your Ram 2500.

LED lights impart a number of advantages when applied in various functions in the Dodge Ram. Not only are LED diodes so small that you could hold more than a dozen in the palm of your hand, but they also take up a fraction of the amount of electricity used by other illumination technologies. LEDs are incredibly bright, producing a sharp, clear beam. Perhaps most impressively, each diode is rated to last 50,000 hours, which equates to 5.7 years of nonstop use.

Replacing the existing taillight assemblies in your Ram with new LED taillights is simple and takes about an hour to complete. Follow these simple instructions to start experiencing the benefits of advanced taillights in your Dodge Ram.

• Turn off the engine and open the tailgate. Pick a side to start with if replacing both assemblies.
• Using a socket wrench, remove the two bolts on the side of the tailgate that hold the taillight assembly in place. Gently wiggle the taillight assembly to free it from the vehicle.
• Disconnect the electrical harness from the back of the taillight assembly. Discard the old assembly and position the new assembly into place.
• Connect the electrical harness and push the new assembly into the cavity. Replace the two bolts to complete installation.
• Repeat these instructions for the opposite side if desired. Step on the brakes to test your new taillights.

Taking advantage of LED technology to produce a prodigious beam of light from your high beams is usually as easy as changing a light bulb. These straightforward instructions make it easy to get started with this technology that is available for your Dodge Ram. Exact instructions may vary with the year of manufacture.

• Turn off the Dodges engine and open the hood. Remove the six retaining pins at the top of the grille cover and remove this piece. The grille will now freely pull away from the vehicle.
• Pick a side to start with. Remove the two bolts from the front of the headlight assembly and press the retainer to free the assembly from the vehicle.
• Pull out the high-beam socket and disconnect the electrical harness. Disconnect the socket from the wiring and connect the wiring to the new LED high beam.
• Insert the LED high beam into the assembly. Place the assembly in the cavity and replace the bolts.
• Repeat these instructions for the opposite side and replace the grille and grille cover.